Dishwashers · Bellevue
Viking Dishwasher Leaves Everything Wet
Some things come out of any dishwasher damp, non-stick pans and plastics above all. When a whole load in a Bellevue kitchen comes out dripping, china and glasses included, what we usually find is an empty rinse-aid reservoir, a short programme, or a door opened the minute the cycle ended. If those are right and the load is still soaked, Viking Repair Bellevue looks at the heating side on (425) 696-2636.
What we usually find
- Most often
Rinse aid run out or dosed too low. It helps water run off instead of beading, Viking's manual names it among the causes of wet dishes, and current panels light a rinse-aid indicator when the reservoir wants filling.
- Sometimes
The load or the programme: bowls nested so water pools in them, a short programme whose cooler rinse leaves less heat to dry with, or unloading the moment it finished.
- Rarely
Heat that never arrives. A failed heating element, or the sensor that reports water temperature, leaves the last rinse lukewarm. On models with a fan-assisted drying system, a fan that has stopped does much the same.
Wet in places, or wet all over
Which items stay wet tells most of the story. Drops on plastic tubs and pooled water in the hollow base of a mug happen on almost any machine. Glassware and china that come out streaming mean the final rinse was not hot enough, or there was no rinse aid to carry the water off.
Tablets have a part in this too. Depending on the model, current Viking panels carry a tablet setting meant to get better drying from all-in-one tablets, and the manual sends owners who see wet dishes with tablets back to the tablet maker first.
Heat at the end of the cycle
Drying depends on the heat the load carries out of the final rinse, which is why a cooler rinse leaves more water behind. A few minutes with the door just ajar, as the manual suggests, lets that heat finish the job instead of condensing back onto the plates.
If rinse aid, the programme, loading and the door are all in order and the load still comes out soaked, the heating side is the likely fault. That is tested with the power isolated and panels off, and it is where the visit begins.
Safe checks before you call
-
Top up the rinse aid
Fill the rinse-aid reservoir on the inside of the door to its MAX mark and wipe up any spill. If it was already full, raise the dose one step; on current Viking panels that is a menu setting that leaves the factory at 3.
-
Pick a longer programme
Viking's manual notes that short programmes rinse cooler and dry less, so try a longer one. Where the panel offers High Gloss, which Viking says gives superior drying, add it and compare.
-
Let it finish, then crack the door
Leave the door shut until the cycle ends, then open it a little and wait before unloading so the steam can escape. Empty the lower rack first so drips from above miss the dry plates.
-
Load so water can run off
Stand cups, glasses and bowls opening-down so no hollow can hold a puddle, keep bowls from nesting inside one another, and give tall glasses room between them.
-
Stop and hand it over
If none of that changes what the Viking is doing, leave it there and ring Viking Repair Bellevue on (425) 696-2636. Tell us what you already tried; it narrows the visit before we set out.
Asked about this
Is it normal for some things to come out wet?
Yes, within limits. Viking's manual accepts that water beads and stays on non-stick surfaces, and plastics hold too little heat to dry fully in most machines. A whole load of wet glass and china is different: that points back to rinse aid, the programme or the heat. Viking Repair Bellevue can help on (425) 696-2636.
